Tabs Cutting and Testing Machine for Polymer Pack Assembling Introduction  1. The equipment is small, easy to operate and the failure rate is ultra-low. 2. The machine solves the problem of cutting short circuit of positive and negative poles of polymer built-in battery at the same time. 3. It is used for cutting the length of positive and negative poles and tabs before welding the protective plate of polymer built-in battery (including mobile phone electricity, mobile power supply, power battery, etc.), 4. The voltage internal resistance test function of the cell is added. If the test value is within the set value range, the device will cut. If the test value is not within the set value range, it will not cut.   Technical parameters: Power Supply 220V 50Hz 30W Air Pressure 0.4-0.8MPa Applicable Battery Range Polymer Cell Maximum Center Width of tab 140mm Minimum Center Width of tab 4mm Minimum Length of tab 3mm Cell Length 30-200mm Cell Width 20-160mm Cell Thickness 2-12mm Overall Dimension 230*180*200mm Weight 8KG